Alaxala AX6700S series Informations techniques

SOFT-AM-0486_R4 AX6700S/AX6600S/AX6300S Software Update Guide July 2011 (Edition 7) 1

2.5 Installation procedure Follow the procedure shown below to install the software: 1) After the Switch is turned on, wait until login: is display

*** Installation on the standby system *** In a BCU, CSU, or MSU single configuration, go to step 8). 7) Execute the ppupdate k.img standby command.

9) Execute the reload no-dump-image command to restart the Switch. Example BOOT-INST-OS# reload no-dump-image Restart OK? (y/n): y (Enter y.) 10)

3 Software update 3.1 Overview of updating software from a remote terminal From a remote terminal, such as a PC, transfer the update file to the

3.2 Preparing to update Table 3-1 shows the conditions required for updating the software. Make sure these conditions are met before updating the so

3.4 Notes on updating the software (1) Notes on transferring the update file  A file must be transferred via FTP in binary mode. Otherwise, execut

Note: The values of x, xxxxxxxx, and xxxxxxxxxxxx vary depending on the status of the active system. Note: These log messages will be displayed in th

3.5 Update procedure The update procedure updates an older version of the software to a newer version. To update the software: 1) Log in to the Sw

4) See the procedure for transferring files described in Appendix to transfer the update file named k.img to the /usr/var/update directory in the Sw

8) Execute the show system command to confirm that the status of the standby system is standby or software version discord. If any configuration ite

 Preface This manual explains how to update the basic software from an older version to a newer version. This manual also describes how to install t

Example # show logging standby Date 20XX/09/19 22:37:41 UTC System information AX6304S, OS-SE Ver. 10.2.A (Build:162), MSU2(standby) (Check

Example # ls -l /usr/var/update total 21040 -rwxrwxrwx 1 root wheel XXXXXXXX Sep 19 22:27 k.img (Check the file size.) # cd /usr/var/update

Example # ppupdate k.img standby (Installation starts.) Software update start Current version is 10.2 New version is 10.2.A (The version o

*** Update when one or more configuration items are not supported in a BCU, CSU, or MSU single configuration or a BCU, CSU, or MSU redundant configu

*** Version after update *** 20) Execute the show logging command to make sure that the abbreviated name and version of the software running on the

25 Appendix - Example procedure for transferring an update file: 1) Open the command prompt window on your PC. 2) Move to the directory containin

 Contents 1 Overview ...

1 Overview 1.1 Overview of updating and installing software There are two ways to set up the software: (1) Perform a software installation from the

Installing from the startup OS Installing from the startup OS means to install software for the first time from the internal flash memory that conta

2 Software installation from the startup OS 2.1 Overview of installing software from the startup OS While the startup OS is running, the IP address

2.2 Preparations for installation Table 2-1 shows the conditions required for an installation. Make sure that these conditions are met before attemp

2.3 Notes on installation (1) Notes on the startup OS The startup OS is dedicated software for installing the basic software. After you log in to th

(2) Notes on transferring the update file  A file must be transferred via FTP in binary mode. Otherwise, execution of the ppupdate command fails. 